Serving the Oil & Gas Industry Since 1980

enfab inc logo
Pressure Regulating Reducing Package

Pressure Reducing Regulating  Skids

In both gas and liquid applications, pressure reduction regulation are required.

 

In a gas distribution system, a network of transmission pipelines transport natural gas from the producing fields to consumers. Gas transmission pipelines normally operate at high pressures.  As customers don't usually require their gas delivered at such high pressures, it is necessary to control the pressure and flow rate.

 

Gas pressure and flows rate are controlled at pressure reduction stations located along the pipeline system. The gas pressure will start in the pipeline above 1,000 psig and end up at a plant or at a residence at a pressure as low as 15 inches of water column. Pressure regulating/reducing skids are packaged stations utilized by gas pipelines.

EN FAB pressure regulating skid

The pressure-reduction system controls the supply pressure to the gas users at a regulated value. Each system consists of at least two trains of pressure reduction – one operating and the other standby.

 

Each train will normally comprise two regulator valves in series.

 

Regulator valves should be sized for the maximum anticipated volumes at the minimum anticipated inlet pressure during those times of maximum volume.

Pressure Reducing Skidded Unit

For stations serving multiple residential customers or other non-interruptible services, sufficient regulator capacity needs to be provided so the failure of one regulator valve run will not reduce the facility capacity below required demand. Regulator valves in custody transfer stations are typically of the type that fail in the open position.

Pressure Regulating Skidded Unit

 

Basic Equipment Detail for Gas Regulating and Metering Station. The Regulating and Metering Station consists of an inlet pipeline with filter separator, pressure regulator, relief valve

 

  • Insulating joint
  • Inlet emergency shut down valve
  • Knock out drum  scrubbers and filter separators.
  • Gas heaters or heat exchanger
  • Valves and valves actuators
  • Slam shut valve
  • Relief valves
  • Pressure regulators
  • Silencers
  • Meters
  • Liquid separator.
  • Pressure Gauge
  • Temperature Gauge
  • Chart recorder
  • Differential pressure transmitter
  • Density and specific gravity transducer
  • Gas Chromatograph
  • Flow Computer
  • Electronic Volume Corrector
  • Supervisory Control and Data Acquisition (SCADA) System
  • Condensate tank
  • Weld-neck Flanges, Blind Flanges, Metallic and Asbestos Gaskets, Tees, Elbows, End caps, Reducers, Saddle/weld-o-lets, Needle valves, Screwed gate and ball valves, Socket welded fittings (Flange, Tee, Elbow, Reducer etc.), Screwed Fittings, SS tubes, Compression Coupling and Stud Blots (As per requirements).
enfab inc logo
Pressure Regulating Reducing Package
enfab inc logo
Pressure Regulating Reducing Package
Pressure Regulating Reducing Package
EN FAB pressure regulating skid
Pressure Reducing Skidded Unit
Pressure Regulating Skidded Unit